myPOWERBLOCK

Network for PowerNation fans

Ethan
Share on Facebook
Share
  • Blog Posts
  • Discussions
  • Events
  • Groups (4)
  • Photos
  • Photo Albums
  • Videos

Ethan's Groups

 

Ethan's Page

Latest Activity

Greg replied to Ethan's discussion Need some expertise. in the group BRONCOS
"If you change the bell housing to a small block bolt pattern it should work. I had an np435 and a 205 in a 75 Bronco."
Jul 8, 2010
Ethan added a discussion to the group BRONCOS
Thumbnail

Need some expertise.

Dose anyone know if a np 435 and a np 205 out of a w300 bolt up to a ford small block? would I just have to switch out the bell housing?
Jul 8, 2010
DAVID replied to Ethan's discussion 300 efi to carb swap in the group Ford F-150's
"Hey Ethan i would think hard about the carb swap i had the same f150 and try what your talking about and it cause me a lot of headaches just my 2cents good luck"
Jun 26, 2010
David replied to Ethan's discussion 300 efi to carb swap in the group Ford F-150's
"I wouldnt bother changing it to carb. efi is alot more effiecient & low maintnants than carb"
Jun 5, 2010
Ethan added a discussion to the group FORD TRUCKS
Thumbnail

300 efi tuner chip

i have heard of people using tuners on efi 300 straight sixes and i was wondering if they help very much or if its a waste of money.
May 30, 2010
Grizzly Bear replied to Ethan's discussion 300 efi to carb swap in the group Ford F-150's
"you fuel milage might go down. typically efi is more fuel effiecient.your also gonna need to cap off the injector holes in the head.you may even need the ignition system off the other truck."
May 27, 2010
Phil Auten replied to Ethan's discussion 300 efi to carb swap in the group FORD TRUCKS
"Check your local/state regulations first. Swapping it to a carb may not allow you to license it for on-road use due to the EPA/state/local laws. Otherwise, besides the intake and carb you will likely need a throttle cable and possibly a bracket or…"
May 27, 2010
Ethan added a discussion to the group FORD TRUCKS
Thumbnail

300 efi to carb swap

hey i have an 89 f150 with a 300 in it and i was thinkin about swapin it to carberated. i can get a complete carbed intake off of an 80 f150. i know ill need to get a fuel pressure regulator but besides that will it bolt right on? is there anything else that im not thinking of and is it even worth it. i am a carb type of guy but if its gonna make it run worse then i prolly wont do it any help would be nice
May 26, 2010

Profile Information

First Name
Ethan

Comment Wall

You need to be a member of myPOWERBLOCK to add comments!

Join myPOWERBLOCK

  • No comments yet!
 
 
 

© 2017   Created by Gearhead.   Powered by

Badges  |  Report an Issue  |  Terms of Service