"Between my brother, my dad, and myself...we have put together many projects over the years (most are pictured in my photos) but this one is the beastliest for nothing working the way it should. Just hoping to get it driveable at this point and…"
"I accepted your friend request because I like guys that work on their cars, and use the low buck approach. I work in a junk yard, so I collect all kind of parts for my projects on the cheap. I just hope I get a chance to use them all. Just bought a…"
"did not change the shift lever. I ended up taking it in for a rebuild. They claim to confirm the gears were stuck. Now I do have all gears again PRND21 but I think it is popping from 1 straight to 3 . They had tried to set it twice and took it…"
"When you changed the shifter arm, did you do the wh*** drop pan, drop valve body, knock out roll pin, replace shaft with original shaft from your trans and then reverse of all prior steps? This is required when swapping Ford trans from different…"
"Thanks Rick, we did pull the linkage off and ran it by hand a few times with the same results. We can only guess that the trans was shot before we ever put it in considering we barley put it in gear and didn't have the reverse. We didn't…"
I accepted your friend request because I like guys that work on their cars, and use the low buck approach. I work in a junk yard, so I collect all kind of parts for my projects on the cheap. I just hope I get a chance to use them all. Just bought a reman (5K) 360 jeep engine for my Javelin. Already have a 400 for my 66 charger, and two 351's for a couple mustang projects on the shelf. I've got to get busy
Thanks for checkin out my page and leaving a comment chuck... Thats a nice cougar in the pic on your page....Nice..Not sure what cars are yours cuz there is so many but that motor in the pic 3 looks like a monster.......
Hey Chuck, it's good to find soone who likes Cougars too. Mine is soo sick, and I'm about sick messing with it. I have about $6,000 in just the engine alone and I cant get it to run right. Everytime I put it on the ground and shift it in gear it sputors and dies. New Carb, timing is right, I just cant figure it out. I'm about to find a sawall and make scrap out of it.