Network for PowerBlock fans

Jeep Motors?

Will a 4.2l 6cyl motor bolt to a 2.5l 4cyl tranny? I am tierd of playing with the 2.5l it will not start it is not getting spark or fuel for some reson? The fuel pump will run when you hook power up to it but it still wont spark? I have no idea?

▶ Reply to This

Replies to This Discussion

Permalink Reply by Kevin on April 19, 2009 at 2:11pm: try checking your ground on the block and the coil.; ▶ Reply to This

Permalink Reply by Trevor Hunter on April 19, 2009 at 5:17pm: i believe the tranny should be the same.
No fuel: have you checked to see if the fuel line is actually pumping fuel? i would check all joints and figure out where you are losing fuel that should address that problem

No Spark: dist or rotor button bad? what have you checked?; ▶ Reply to This